1. Pull outward on each leg near the top of the easel to release legs.
2. Unfold all three legs until they lock into extended position.
3. Pull outward on lower end of center leg until it locks into position

Replacing paper:

Older Models

1. Remove the two knurled nuts located near the top of the back side of the easel.
2. Remove pad hold-down bracket and old pad.
3. Align new pad with protruding pins in hold-down bracket
4. Align hold-down bracket pins (sticking through new pad) with holes in easel and insert
5. Replace the two knurled nuts to secure hold-down bracket and pad in place.

Newer Models

1. Lift up on hold-down bracket at top of easel.
2. Remove old pad and discard.
3. Align new pad with pins at top of easel, dropping pad into place over pins
4. Release hold-down bracket

Folding:

1. Depress release lever at back of leg hinge to release leg.
2. Fold leg back over itself and latch over spring clip
3. To fold center leg, depress button on front of upper leg section
   
   CAUTION: Do not attempt to force the center leg against the easel. Be sure to press the release button before attempting to fold the leg back, otherwise the leg and the support arms will be damaged!
   
   

Rev. 0.1 - DCAjr - 07/22/1998--HTML 12/30/1999