| Common Name: | 18320 THE END. WASP & HORNET KILLER |
| Manufacturer: | ITW DYMON |
| MSDS Revision Date: | 4/3/2000 |
| Grainger Item Number(s): | 3U026, 3ZH55 |
| Manufacturer Model Number(s): | 85861 |
MSDS Table of Contents
Click the desired link below to jump directly to that section in the MSDS.
MATERIAL SAFETY DATA SHEET
MAY BE USED TO COMPLY WITH OSHA'S HAZARD COMMUNICATION STANDARD,
29 CFR 1910.1200. STANDARD MUST BE CONSULTED FOR SPECIFIC REQUIREMENTS.
HMIS(R*):
HEALTH 1
FLAMMABILITY 2
REACTIVITY 1
PERSONAL PROTECTION A
IDENTITY (AS USED ON LABEL AND LIST):
18320 THE END.(TM) WASP & HORNET KILLER
EPA REG. NO.: 11694-109
NOTE:
BLANK SPACES ARE NOT PERMITTED. IF ANY ITEM IS NOT APPLICABLE, OR NO
INFORMATION IS AVAILABLE, THE SPACE MUST BE MARKED TO INDICATE THAT.
| SECTION I |  |
MANUFACTURER'S NAME: ITW DYMON
ADDRESS (NUMBER, STREET, CITY, STATE, AND ZIP CODE):
805 EAST OLD 56 HIGHWAY
OLATHE, KANSAS 66061
EMERGENCY TELEPHONE NUMBER: 1.800.535.5053
TELEPHONE NUMBER FOR INFORMATION: 1.913.397.9889
DATE PREPARED: APRIL 3, 2000
SIGNATURE OF PREPARER (OPTIONAL): REGULATORY DEPT.
| SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION | |
HAZARDOUS COMPONENTS CAS NO. OSHA ACGIH- OTHER LIMITS % (OPT.)
(SPECIFIC CHEMICAL PEL TLV RECOMMENDED
IDENTITY, COMMON
NAME(S))
ALIPHATIC 64742-47-8 NOT NOT 100 PPM MANU. 60-100%
HYDROCARBON ESTAB. ESTAB.
CARBON DIOXIDE 124-38-9 5000 PPM 5000 STEL: 3.0-7.0%
PPM 30000 PPM
THIS PRODUCT IS NOT KNOWN TO CONTAIN ANY COMPOUND LISTED AND IN QUANTITIES
REQUIRING REPORTING UNDER SARA TITLE III SECTION 313.
TSCA:
ALL INGREDIENTS ARE ON THE TSCA INVENTORY OR ARE NOT REQUIRED TO BE LISTED
ON THE TSCA INVENTORY.
ANY SUBSTANCE LISTED AS HAZARDOUS BY THE STATES OF CALIFORNIA, FLORIDA,
ILLINOIS, MASSACHUSETTS, MICHIGAN, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA
OR TEXAS IS DESCRIBED ABOVE IF KNOWN PRESENT IN REGULATED CONCENTRATIONS.
| SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS | |
BOILING POINT CONCENTRATE: 369 DEG. F
SPECIFIC GRAVITY (H2O = 1) CONCENTRATE @ 70 DEG. F: 0.789
PRESSURE (PSIG. @ 70 DEG. F): 90+/-5
MELTING POINT: NO DATA
VAPOR DENSITY (AIR = 1): GREATER THAN ONE (1)
EVAPORATION RATE (BUTYL ACETATE = 1): NO DATA
SOLUBILITY IN WATER: NEGLIGIBLE
pH: NOT APPLICABLE
APPEARANCE AND ODOR:
CLEAR COLORLESS LIQUID WITH A SLIGHT PETROLEUM ODOR IN AN AEROSOL CAN.
| SECTION IV - FIRE AND EXPLOSION HAZARD DATA | |
USA FLAME PROJECTION TEST (ASTM D-3065): 0", NO FLASHBACK
FLAMMABLE LIMITS: NO DATA
LEL: NO DATA
UEL: NO DATA
EXTINGUISHING MEDIA:
TREAT AS AN OIL FIRE. WATER MAY CAUSE FIRE TO FLOAT AND SPREAD. USE CARBON
DIOXIDE, DRY CHEMICAL OR FOAM.
SPECIAL FIRE FIGHTING PROCEDURES:
USE WATER SPRAY TO KEEP CONTAINERS COOL AND VAPORS DOWN. DO NOT ALLOW
RUNOFF TO ENTER SEWERS OR PUBLIC WATERCOURSES. WEAR SELF-CONTAINED
BREATHING APPARATUS IN CHEMICAL FIRES.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
AEROSOL CONTAINER (PRESSURIZED) MAY BURST IF HEATED OVER 130 DEG. F.
COMBUSTIBLE CONTENTS.
| SECTION V - REACTIVITY DATA | |
STABILITY:
UNSTABLE ( )
STABLE (X)
CONDITIONS TO AVOID: EXTREME HEAT, DIRECT SUNLIGHT
INCOMPATIBILITY (MATERIALS TO AVOID):
STRONG OXIDIZING AGENTS, ALKALI METALS, ALKALINE EARTH METALS, METAL
ACETYLHALIDES AND CHROMIUM.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS:
CARBON DIOXIDE, CARBON MONOXIDE, OXYGEN, SMOKE, SOOT AND VARIOUS ORGANIC
OXIDATION BY-PRODUCTS.
HAZARDOUS POLYMERIZATION:
MAY OCCUR ( )
WILL NOT OCCUR (X)
CONDITIONS TO AVOID: NONE KNOWN
| SECTION VI - HEALTH HAZARD DATA | |
ROUTE(S) OF ENTRY:
EYES?: YES
INHALATION?: YES
SKIN?: YES
INGESTION?: YES
HEALTH HAZARDS (ACUTE AND CHRONIC):
CAUTION. CAUSES MODERATE EYE IRRITATION. MAY CAUSE SKIN IRRITATION.
UNLIKELY TO BE SWALLOWED, BUT CONTAINS PETROLEUM DISTILLATES WHICH MAY
PRESENT AN ASPIRATION HAZARD IF SWALLOWED. MAY BE HARMFUL IF INHALED.
PROLONGED OR FREQUENTLY REPEATED SKIN CONTACT MAY CAUSE ALLERGIC REACTIONS
IN SOME INDIVIDUALS. FOLLOW LABEL INSTRUCTIONS AND GOOD CHEMICAL HYGIENE
PRACTICES TO AVOID THESE HAZARDS.
CARCINOGENICITY: NONE LISTED
NTP?: NO
IARC MONOGRAPHS?: NO
OSHA REGULATED?: NO
SIGNS AND SYMPTOMS OF EXPOSURE:
REDNESS, DRYNESS, SCALING OR ITCHING SKIN. EXCESSIVE INHALATION OF VAPORS
MAY CAUSE HEADACHES, STUPOR, OR IRRITATION OF THROAT AND EYES. SWALLOWING
MAY CAUSE IRRITATION OF STOMACH AND INTESTINES RESULTING IN NAUSEA AND
VOMITING.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
PRE-EXISTING SKIN AND KIDNEY CONDITIONS MAY BE ADVERSELY AFFECTED. FOLLOW
GOOD CHEMICAL HYGIENE PRACTICES TO AVOID THIS HAZARD.
EMERGENCY AND FIRST AID PROCEDURES:
EYES:
FLUSH WITH PLENTY OF WATER (FOR AT LEAST 15 MINUTES LIFTING EYELIDS TO
INSURE COMPLETE REMOVAL.) CALL A PHYSICIAN IF IRRITATION PERSISTS.
INGESTION:
UNLIKELY FROM AEROSOL CAN. IF LARGE QUANTITIES ARE SWALLOWED, CALL A
PHYSICIAN OR POISON CONTROL CENTER IMMEDIATELY. GET IMMEDIATE MEDICAL
ATTENTION.
INHALATION:
GET TO FRESH AIR. IF BREATHING HAS STOPPED, QUALIFIED PERSONNEL SHOULD
ADMINISTER ARTIFICIAL RESPIRATION.
SKIN:
WASH THOROUGHLY WITH SOAP AND WATER. REMOVE CONTAMINATED CLOTHING AND
SHOES. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE. CALL A PHYSICIAN IF
IRRITATION ARISES AND PERSISTS.
NOTE TO PHYSICIAN: CONTAINS PETROLEUM DISTILLATES (>80%).
| SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE | |
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
CAUTION, SLIP HAZARD. WIPE UP SMALL SPILLS PROMPTLY. THOROUGHLY CLEAN ANY
RESIDUES WITH AN EFFECTIVE CLEANING COMPOUND. FOR LARGE SPILLS, ISOLATE
TRAFFIC AND VENTILATE AREA. ELIMINATE ALL IGNITION SOURCES. WEAR PROTECTIVE
GEAR AS NECESSARY. DIKE TO PREVENT SPREAD. PREVENT FROM ENTERING DRAINS,
SEWERS OR ANY WATERCOURSE OR WATERWAY. PICK UP WITH AN ABSORBENT MATERIAL.
PUT IN A SUITABLE CONTAINER FOR PROPER DISPOSAL. THIS PRODUCT IS TOXIC TO
FISH AND AQUATIC INVERTEBRATES.
WASTE DISPOSAL METHOD:
CONSULT LOCAL, STATE AND FEDERAL REGULATIONS. REPLACE CAP. WRAP (EMPTY)
CONTAINER IN SEVERAL LAYERS OF NEWSPAPER AND DISCARD IN TRASH. DO NOT
INCINERATE OR PUNCTURE. CAN MAY BE DISPOSED OF WITH OTHER RECYCLABLES WHERE
LOCAL LAW PERMITS.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
AVOID CONTACT WITH EYES OR CLOTHING. WASH THOROUGHLY WITH SOAP AND WATER
AFTER HANDLING. DO NOT SWALLOW. AVOID INHALING MIST OR VAPORS. USE WITH
ADEQUATE VENTILATION. KEEP AWAY FROM HEAT, SPARKS AND OPEN FLAME. EXPOSURE
TO TEMPERATURES ABOVE 130 DEG. F MAY CAUSE BURSTING. STORE IN A COOL (UNDER
130 DEG. F) DRY LOCATION AWAY FROM HEAT, SPARKS, OPEN FLAME, AND DIRECT
SUNLIGHT.
OTHER PRECAUTIONS:
FOLLOW LABEL DIRECTIONS CAREFULLY. KEEP OUT OF REACH OF CHILDREN. DO NOT
DELIBERATELY CONCENTRATE AND INHALE VAPORS. DIRECT SPRAY AWAY FROM FACE.
REPLACE CAN WHEN NOT IN USE. DO NOT USE AROUND IGNITION SOURCES SUCH AS
HEAT, SPARKS, OPEN FLAME, STATIC ELECTRICITY, ELECTRIC MOTORS, WELDING
ARCS, ETC. DO NOT PUNCTURE OR INCINERATE CONTAINER. DO NOT SMOKE WHILE
USING. DO NOT APPLY DIRECTLY TO WATER.
| SECTION VIII - CONTROL MEASURES | |
RESPIRATORY PROTECTION (SPECIFY TYPE):
NOT USUALLY NECESSARY. USE WITH ADEQUATE VENTILATION. IF PELS OR TLVS ARE
EXCEEDED (SEE SECTION II), FOLLOW NIOSH\MSHA RECOMMENDATIONS.
VENTILATION:
LOCAL EXHAUST: NOT USUALLY NEEDED
MECHANICAL (GENERAL): ACCEPTABLE
SPECIAL: NONE
OTHER: NONE
PROTECTIVE GLOVES:
NOT USUALLY NEEDED. IF DIRECT CONTACT IS POSSIBLE, WEAR CHEMICAL RESISTANT.
EYE PROTECTION: YES, GOGGLES OR APPROVED SAFETY GLASSES (ANSI Z87)
OTHER PROTECTIVE CLOTHING OR EQUIPMENT:
NOT USUALLY NECESSARY. IF DIRECT CONTACT IS POSSIBLE, WEAR APRON, BOOTS,
FACE SHIELD, GLOVES, ETC. AS NECESSARY.
WORK/HYGIENIC PRACTICES:
NORMAL. WASH THOROUGHLY BEFORE EATING, DRINKING, SMOKING, USING RESTROOMS,
ETC.
WARNING!
THE USE OF THIS PRODUCT IS BEYOND THE CONTROL OF THE MANUFACTURER;
THEREFORE, NO GUARANTEE, EXPRESSED OR IMPLIED, IS MADE AS TO THE EFFECTS
OF SUCH OR THE RESULTS TO BE OBTAINED IF NOT USED IN ACCORDANCE WITH
DIRECTIONS OR ESTABLISHED SAFE PRACTICE. THE USER MUST ASSUME ALL
RESPONSIBILITY, INCLUDING INJURY OR DAMAGE, RESULTING FROM ITS MISUSE AS
SUCH, OR IN COMBINATION WITH OTHER MATERIALS.
THE MANUFACTURER WARRANTS ONLY THAT THIS PRODUCT MEETS THE MANUFACTURER'S
SPECIFICATIONS FOR SUCH PRODUCT. THIS WARRANTY IS IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, AS TO DESCRIPTION, QUALITY, AND
MERCHANTABILITY, FITNESS FOR ANY PARTICULAR PURPOSE, PRODUCTIVENESS, OR ANY
OTHER MATTER, OF THIS PRODUCT. THE MANUFACTURER SHALL BE IN NO WAY
RESPONSIBLE FOR THE IMPROPER USE OF THIS PRODUCT. THE SOLE AND EXCLUSIVE
REMEDY AGAINST THE MANUFACTURER FOR BREACH OF WARRANTY SHALL BE
REIMBURSEMENT OF THE PURCHASE PRICE OF THE PRODUCT IN THE EVENT THAT A
DEFECTIVE CONDITION OF THE PRODUCT SHALL BE FOUND TO EXIST. NO OTHER REMEDY
(INCLUDING BUT NOT LIMITED TO INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR
INJURY TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL LOSS)
SHALL BE AVAILABLE.