| Common Name: | FOAM FAST 74 SPRAY ADHESIVE AND FOAM FAST 74 CYLINDER SPRAY ADHESIVE |
| Manufacturer: | 3M |
| MSDS Revision Date: | 5/24/2001 |
| Grainger Item Number(s): | 3XH53, 8DZ97 |
| Manufacturer Model Number(s): | 62-4991-4936-7, 74 |
MSDS Table of Contents
Click the desired link below to jump directly to that section in the MSDS.
| 1. INGREDIENT |
| 2. PHYSICAL DATA |
| 3. FIRE AND EXPLOSION HAZARD DATA |
| 4. REACTIVITY DATA |
| 5. ENVIRONMENTAL INFORMATION |
| 6. SUGGESTED FIRST AID |
| 7. PRECAUTIONARY INFORMATION |
| 8. HEALTH HAZARD DATA |
MATERIAL SAFETY DATA SHEET
3M
3M CENTER
ST. PAUL, MINNESOTA 55144-1000
1-800-364-3577 OR (651) 737-6501 (24 HOURS)
COPYRIGHT, 2001, MINNESOTA MINING AND MANUFACTURING COMPANY. ALL RIGHTS
RESERVED. COPYING AND/OR DOWNLOADING OF THIS INFORMATION FOR THE PURPOSE OF
PROPERLY UTILIZING 3M PRODUCTS IS ALLOWED PROVIDED THAT:
1) THE INFORMATION IS COPIED IN FULL WITH NO CHANGES UNLESS PRIOR AGREEMENT
IS OBTAINED FROM 3M, AND
2) NEITHER THE COPY NOR THE ORIGINAL IS RESOLD OR OTHERWISE DISTRIBUTED
WITH THE INTENTION OF EARNING A PROFIT THEREON.
DIVISION: ENGINEERED ADHESIVES
TRADE NAME:
3M(TM) FOAM FAST 74 SPRAY ADHESIVE AND 3M(TM) FOAM FAST 74 CYLINDER SPRAY
ADHESIVE
ID NUMBER/U.P.C.:
62-4991-0026-1 62-4991-0047-7
62-4991-0930-4 00-21200-31320-2 62-4991-0931-2
62-4991-4930-0 00-21200-65055-0 62-4991-4935-9
62-4991-4936-7 00-21200-82242-1 62-4991-4937-5 00-21200-82242-0
62-4991-4938-3 62-4991-7830-9 00-21200-49157-3
62-4991-8830-8 00-21200-49158-0 62-4991-8835-7 00-21200-49158-9
CS-0406-2031-5 CS-0406-6932-0
ISSUED: MAY 24, 2001
SUPERSEDES: APRIL 03, 2001
DOCUMENT: 10-3323-2
| 1. INGREDIENT |  |
INGREDIENT C.A.S. NO. PERCENT
DIMETHYL ETHER 115-10-6 30.0 - 40.0
PENTANE 109-66-0 20.0 - 30.0
NON-VOLATILE COMPONENTS - N.J. TRADE TRADESECRET 20.0 - 30.0
SECRET (T.S.) REGISTRY NO. 04499600-5490P ++
ACETONE 67-64-1 7.0 - 13.0
NAPHTHOL SPIRITS 64742-48-9 1.0 - 5.0
IN CASE OF EMERGENCY:
THE NUMBERS AT THE TOP OF THIS MSDS PROVIDE 24 HOUR RESPONSE FROM ANY PHONE
FOR ALL EMERGENCIES WITH THIS PRODUCT. THE COMPONENTS OF THIS PRODUCT ARE
IN COMPLIANCE WITH THE CHEMICAL NOTIFICATION REQUIREMENTS OF TSCA.
++ SYNTHETIC POLYMERS, RESINS, FILLER, ANTIOXIDANT, ROSIN AND U.V.
ABSORBER. NOT HAZARDOUS ACCORDING TO CANADIAN WHMIS CRITERIA. NON-WHMIS
CONTROLLING.
| 2. PHYSICAL DATA | |
BOILING POINT: N/A
VAPOR PRESSURE: COMPRESSED GAS
VAPOR DENSITY: >2.00 AIR = 1
EVAPORATION RATE: 2.00 ETHER = 1
SOLUBILITY IN WATER: NIL
SPECIFIC GRAVITY: 0.725 WATER = 1
PERCENT VOLATILE: CA. 78 % BY WT
pH: N/D
VISCOSITY: N/A
MELTING POINT: N/D
APPEARANCE AND ODOR: LIQUID IN AEROSOL, ORANGE, SWEET/FRUITY ODOR.
| 3. FIRE AND EXPLOSION HAZARD DATA | |
FLASH POINT: -50.00 F TCC (PROPELLANT)
FLAMMABLE LIMITS - LEL: 1.00 % BY VOL
FLAMMABLE LIMITS - UEL: FLAMMABLE GAS
AUTOIGNITION TEMPERATURE: N/D
EXTINGUISHING MEDIA: WATER SPRAY, CARBON DIOXIDE, DRY CHEMICAL, FOAM
SPECIAL FIRE FIGHTING PROCEDURES:
WEAR FULL PROTECTIVE CLOTHING, INCLUDING HELMET, SELF-CONTAINED, POSITIVE
PRESSURE OR PRESSURE DEMAND BREATHING APPARATUS, BUNKER COAT AND PANTS,
BANDS AROUND ARMS, WAIST AND LEGS, FACE MASK, AND PROTECTIVE COVERING FOR
EXPOSED AREAS OF THE HEAD. WATER MAY NOT EFFECTIVELY EXTINGUISH FIRE;
HOWEVER, IT SHOULD BE USED TO KEEP FIRE-EXPOSED CONTAINERS AND SURFACES
COOL AND PREVENT EXPLOSIVE RUPTURE.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
CLOSED CONTAINERS EXPOSED TO HEAT FROM FIRE MAY BUILD PRESSURE AND EXPLODE.
VAPORS MAY TRAVEL LONG DISTANCES ALONG THE GROUND OR FLOOR TO AN IGNITION
SOURCE AND FLASH BACK.
NFPA HAZARD CODES:
HEALTH 2
FIRE 4
REACTIVITY 1
AEROSOL STORAGE 2
UNUSUAL REACTION HAZARD: NONE
| 4. REACTIVITY DATA | |
STABILITY: STABLE
INCOMPATIBILITY - MATERIALS/CONDITIONS TO AVOID: HEAT.
HAZARDOUS POLYMERIZATION: HAZARDOUS POLYMERIZATION WILL NOT OCCUR.
HAZARDOUS DECOMPOSITION PRODUCTS:
CARBON MONOXIDE AND CARBON DIOXIDE, ALDEHYDES, KETONES, HYDROCARBONS.
| 5. ENVIRONMENTAL INFORMATION | |
SPILL RESPONSE:
REFER TO OTHER SECTIONS OF THIS MSDS FOR INFORMATION REGARDING PHYSICAL
AND HEALTH HAZARDS, RESPIRATORY PROTECTION, VENTILATION, AND PERSONAL
PROTECTIVE EQUIPMENT. VENTILATE AREA. EXTINGUISH ALL IGNITION SOURCES.
COVER WITH ABSORBENT MATERIAL. COLLECT USING NON-SPARKING TOOLS. PLACE IN
A U.S. DOT-APPROVED CONTAINER.
RECOMMENDED DISPOSAL:
INCINERATE IN A PERMITTED HAZARDOUS WASTE INCINERATOR IN THE PRESENCE OF A
COMBUSTIBLE MATERIAL. FACILITY MUST BE CAPABLE OF HANDLING AEROSOL CANS.
DISPOSE OF EMPTY CANS IN A SANITARY LANDFILL. DISPOSE OF COMPLETELY
ABSORBED WASTE PRODUCT IN A FACILITY PERMITTED TO ACCEPT CHEMICAL WASTES.
RECYCLE EMPTY AEROSOL CONTAINERS WHERE AVAILABLE.
ENVIRONMENTAL DATA: NOT DETERMINED.
REGULATORY INFORMATION:
VOLATILE ORGANIC COMPOUNDS: CA. 66 % BY WT.
VOC LESS H2O & EXEMPT SOLVENTS:
CA. 563 GMS/LITER CALCULATED PER SCAQMD RULE 443.1.
HAZARDOUS AIR POLLUTANTS: 0 % BY WT CALCULATED.
SINCE REGULATIONS VARY, CONSULT APPLICABLE REGULATIONS OR AUTHORITIES
BEFORE DISPOSAL. U.S. EPA HAZARDOUS WASTE NUMBER: D001 (IGNITABLE)
EPCRA HAZARD CLASS:
FIRE HAZARD: YES
PRESSURE: YES
REACTIVITY: NO
ACUTE: YES
CHRONIC: YES
| 6. SUGGESTED FIRST AID | |
EYE CONTACT:
IMMEDIATELY FLUSH EYES WITH LARGE AMOUNTS OF WATER. GET IMMEDIATE MEDICAL
ATTENTION.
SKIN CONTACT:
FLUSH SKIN WITH LARGE AMOUNTS OF WATER. IF IRRITATION PERSISTS, GET MEDICAL
ATTENTION.
INHALATION:
REMOVE PERSON TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION.
IF BREATHING IS DIFFICULT, GET IMMEDIATE MEDICAL ATTENTION.
IF SWALLOWED:
DO NOT INDUCE VOMITING. DRINK TWO GLASSES OF WATER. CALL A PHYSICIAN.
| 7. PRECAUTIONARY INFORMATION | |
EYE PROTECTION:
AVOID EYE CONTACT WITH VAPOR, SPRAY, OR MIST. WEAR SAFETY GLASSES WITH SIDE
SHIELDS.
SKIN PROTECTION: AVOID PROLONGED OR REPEATED SKIN CONTACT.
RECOMMENDED VENTILATION:
DO NOT USE IN A CONFINED AREA OR AREAS WITH LITTLE OR NO AIR MOVEMENT. IF
EXHAUST VENTILATION IS NOT ADEQUATE, USE APPROPRIATE RESPIRATORY
PROTECTION. PROVIDE VENTILATION ADEQUATE TO CONTROL VAPOR CONCENTRATIONS
BELOW RECOMMENDED EXPOSURE LIMITS AND/OR CONTROL SPRAY OR MIST.
RESPIRATORY PROTECTION:
AVOID BREATHING OF VAPORS, MISTS OR SPRAY. SELECT ONE OF THE FOLLOWING
NIOSH APPROVED RESPIRATORS BASED ON AIRBORNE CONCENTRATION OF CONTAMINANTS
AND IN ACCORDANCE WITH OSHA REGULATIONS: HALF-MASK ORGANIC VAPOR
RESPIRATOR.
PREVENTION OF ACCIDENTAL INGESTION: DO NOT INGEST.
RECOMMENDED STORAGE:
STORE AT TEMPERATURES BELOW 120 DEGREES F (49 DEGREES C). STORE OUT OF
DIRECT SUNLIGHT. KEEP OUT OF THE REACH OF CHILDREN.
FIRE AND EXPLOSION AVOIDANCE:
AEROSOL CONTAINER CONTAINS FLAMMABLE GAS UNDER PRESSURE. KEEP AWAY FROM
HEAT, SPARKS, OPEN FLAME, AND OTHER SOURCES OF IGNITION. EXTREMELY
FLAMMABLE LIQUID AND VAPOR. DO NOT PIERCE OR BURN CONTAINER, EVEN AFTER
USE. NO SMOKING WHILE HANDLING THIS MATERIAL. AVOID STATIC DISCHARGE.
EXPOSURE LIMITS
INGREDIENT VALUE UNIT TYPE AUTH SKIN*
DIMETHYL ETHER 1000 PPM TWA CMRG
DIMETHYL ETHER 500 PPM TWA AIHA
PENTANE 600 PPM TWA ACGIH
PENTANE 600 PPM TWA OSHAV
OSHA VACATED PEL
PENTANE 750 PPM STEL OSHAV
OSHA VACATED PEL
PENTANE 1000 PPM TWA OSHA
NON-VOLATILE COMPONENTS - N.J. NONE NONE NONE NONE
TRADE SECRET (T.S.)
REGISTRY NO. 04499600-5490P ++
ACETONE 500 PPM TWA ACGIH
ACETONE 750 PPM STEL ACGIH
ACETONE 750 PPM TWA OSHAV
OSHA VACATED PEL
ACETONE 1000 PPM STEL OSHAV
OSHA VACATED PEL
ACETONE 1000 PPM TWA OSHA
NAPHTHOL SPIRITS 100 PPM TWA 3M
NAPHTHOL SPIRITS 300 PPM TWA CMRG
* SKIN NOTATION:
LISTED SUBSTANCES INDICATED WITH 'Y' UNDER SKIN REFER TO THE POTENTIAL
CONTRIBUTION TO THE OVERALL EXPOSURE BY THE CUTANEOUS ROUTE INCLUDING
MUCOUS MEMBRANE AND EYE, EITHER BY AIRBORNE OR, MORE PARTICULARLY, BY
DIRECT CONTACT WITH THE SUBSTANCE. VEHICLES CAN ALTER SKIN ABSORPTION.
SOURCE OF EXPOSURE LIMIT DATA:
3M: 3M RECOMMENDED EXPOSURE GUIDELINES
ACGIH: AMERICAN CONFERENCE OF GOVERNMENTAL INDUSTRIAL HYGIENISTS
AIHA:
AMERICAN INDUSTRIAL HYGIENE ASSOC. WORKPLACE ENVIRONMENTAL EXPOSURE LEVEL
GUIDELINE
CMRG: CHEMICAL MANUFACTURER RECOMMENDED EXPOSURE GUIDELINES
OSHA: OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION
OSHAV:
OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION VACATED PEL.
VACATED PERMISSIBLE EXPOSURE LIMITS (PEL) ARE ENFORCED AS THE OSHA PEL IN
SOME STATES. CHECK WITH YOUR LOCAL REGULATORY AUTHORITY.
NONE: NONE ESTABLISHED
| 8. HEALTH HAZARD DATA | |
EYE CONTACT:
MODERATE EYE IRRITATION:
SIGNS/SYMPTOMS CAN INDUCE REDNESS, SWELLING, PAIN, TEARING, AND HAZY
VISION.
SKIN CONTACT:
MILD SKIN IRRITATION (AFTER PROLONGED OR REPEATED CONTACT):
SIGNS/SYMPTOMS CAN INCLUDE REDNESS, SWELLING, AND ITCHING.
INHALATION:
INTENTIONAL CONCENTRATION AND INHALATION MAY BE HARMFUL OR FATAL.
CENTRAL NERVOUS SYSTEM DEPRESSION:
SIGNS/SYMPTOMS CAN INCLUDE HEADACHE, DIZZINESS, DROWSINESS, INCOORDINATION,
SLOWED REACTION TIME, SLURRED SPEECH, GIDDINESS AND UNCONSCIOUSNESS.
IRRITATION (UPPER RESPIRATORY):
SIGNS/SYMPTOMS CAN INCLUDE SORENESS OF THE NOSE AND THROAT, COUGHING AND
SNEEZING.
IF SWALLOWED: INGESTION IS NOT A LIKELY ROUTE OF EXPOSURE TO THIS PRODUCT.
WHILE THE FOLLOWING EFFECTS ARE ASSOCIATED WITH ONE OR MORE OF THE
INDIVIDUAL INGREDIENTS IN THIS PRODUCT AND ARE REQUIRED TO BE INCLUDED ON
THE MSDS BY THE U.S. OSHA HAZARD COMMUNICATION STANDARD, THEY ARE NOT
EXPECTED EFFECTS DURING FORESEEABLE USE OF THIS PRODUCT.
IRRITATION OF GASTROINTESTINAL TISSUES:
SIGNS/SYMPTOMS CAN INCLUDE PAIN, VOMITING, ABDOMINAL TENDERNESS, NAUSEA,
BLOOD IN VOMITUS, AND BLOOD IN FECES.
SECTION CHANGE DATES:
HEADING SECTION CHANGED SINCE APRIL 03, 2001 ISSUE
ABBREVIATIONS:
N/D - NOT DETERMINED
N/A - NOT APPLICABLE
CA - APPROXIMATELY
THE INFORMATION IN THIS MATERIAL SAFETY DATA SHEET (MSDS) IS BELIEVED TO BE
CORRECT AS OF THE DATE ISSUED. 3M MAKES NO WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR COURSE OF
PERFORMANCE OR USAGE OF TRADE. USER IS RESPONSIBLE FOR DETERMINING WHETHER
THE 3M PRODUCT IS FIT FOR A PARTICULAR PURPOSE AND SUITABLE FOR USER'S
METHOD OF USE OR APPLICATION. GIVEN THE VARIETY OF FACTORS THAT CAN AFFECT
THE USE AND APPLICATION OF A 3M PRODUCT, SOME OF WHICH ARE UNIQUELY WITHIN
THE USER'S KNOWLEDGE AND CONTROL, IT IS ESSENTIAL THAT THE USER EVALUATE
THE 3M PRODUCT TO DETERMINE WHETHER IT IS FIT FOR A PARTICULAR PURPOSE AND
SUITABLE FOR USER'S METHOD OF USE OR APPLICATION.
3M PROVIDES INFORMATION IN ELECTRONIC FORM AS A SERVICE TO ITS CUSTOMERS.
DUE TO THE REMOTE POSSIBILITY THAT ELECTRONIC TRANSFER MAY HAVE RESULTED IN
ERRORS, OMISSIONS OR ALTERATIONS IN THIS INFORMATION, 3M MAKES NO
REPRESENTATIONS AS TO ITS COMPLETENESS OR ACCURACY. IN ADDITION,
INFORMATION OBTAINED FROM A DATABASE MAY NOT BE AS CURRENT AS THE
INFORMATION IN THE MSDS AVAILABLE DIRECTLY FROM 3M.